Advantages and uses of large inclination belt conveyor

Steep incline conveyors, also known as sidewall conveyors or large angle belt conveyors, are a great substitute for drag chain or conveyor/bucket elevator configurations, because of the reduced noise and the elimination of transfer points. Large angle conveyor is a new type of belt conveyor, also known as corrugated sidewall large angle belt conveyor, which is very good for continuous conveying of bulk materials.

Advantages and uses of large inclination belt conveyor:

Conveyor belt with corrugated ribs: it plays the role of traction and bearing in the conveyor. The corrugated ribs, the transverse partition and the base belt form a gate-shaped container for conveying materials, so as to realize a large inclination conveyance.

Drive: It is the power part of the conveyor. It is composed of Y series motor, ZJ type shaft-mounted reducer and wedge type backstop.

Drive roller: It is the main part of power transmission, and the conveyor belt runs by the friction between it and the drive roller. This series of drive rollers are divided into rubber surface and smooth surface. The rubber surface roller is to increase the adhesion between the roller and the conveyor belt.

Redirection roller: used to change the running direction of the conveyor belt. The reversing roller is used on the lower surface of the conveyor belt (non-bearing surface).

Pressure roller: Used to change the running direction of the conveyor belt, and the pressure roller is used on the upper surface (loading surface) of the conveyor belt.

Roller: Roller is used to support the conveyor belt and the material on the belt to make it run stably. This series has two types: upper parallel roller and lower flat roller.

Carrier roller: The carrier roller is used to support the lower branch of the conveyor belt on the convex arc section frame, and it is supported on the empty edges on both sides of the rib conveyor belt. Several groups of belt rollers form a circular arc section to redirect the conveyor belt. The supporting roller adopts cantilever support.

Vertical roller: The vertical roller is used to limit the deviation of the conveyor belt, and is installed on the upper and lower transition frame. Each filter section frame is equipped with four, two upper and lower sections.

Flap wheel cleaning device: used to tap the back of the conveyor belt to shake off the material sticking to the conveyor belt.

Tensioning device: Its functions are: 1. Make the conveyor belt have enough tension to ensure that the conveyor belt and the drive roller do not slip. 2. Limit the sag of the conveyor belt between the supports to make the conveyor run normally. This series adopts spiral tensioning device.

Frame, head funnel, head guard, material guide trough, intermediate frame, intermediate frame legs, etc.: play supporting, dustproof and material guiding functions in the conveyor. There are three types of middle frame legs in this series: low, Chinese and high. The lower horizontal section and tilt are only equipped with low intermediate frame legs, while the upper and lower horizontal sections are equipped with different intermediate frame legs (low, Chinese and high) according to different head frames (low, Chinese and high head frames). High intermediate frame legs).